Hi Jeremy When I was setting up the box, I had the possibility to use all six nics, but I'm only using three. Dual Wan (2x10/100) and one Lan (1x10/100/1000) configured with a management vlan.
There are approximately 60 users connected to this box, and it has not been really busy yet... Kind regards Anders Dahl -----Oprindelig meddelelse----- Fra: Jeremy Bennett [mailto:[EMAIL PROTECTED] Sendt: 5. november 2007 06:37 Til: [email protected] Emne: Re: SV: [pfSense Support] New Build Anders, Thank you for your firsthand account. I was looking at this unit, but concerned about the realtek nics... I've had problems with those in the past, but if it works for you, then I'm interested. Are you able to use each of the 6 lan ports on this unit as a different interface/ subnet in PFsense? If so, PFsense makes this a heavy duty little box. (too bad about the current USD exchange rate though). Thanks Again, Jeremy On Nov 4, 2007, at 6:57 PM, Anders Dahl wrote: > Hi Mahalo > > I've been running 1.0.1-embedded on a FX5620, available at linitx.com > http://linitx.com/viewproduct.php?prodid=10909. > > It's been running now for 6 months, without any problems at all. > > Kind regards > > Anders Dahl > > -----Oprindelig meddelelse----- > Fra: Jeremy Bennett [mailto:[EMAIL PROTECTED] > Sendt: 5. november 2007 05:00 > Til: [email protected] > Emne: [pfSense Support] New Build > > I've been running PFsense successfully on a handbuilt PC for about a > year now, and am stoked that it works so well. I'd like to move onto > the next step and do an embedded setup. Can anyone recommend the best > board/vendor for this approach? > > I'd like to have at minimum 3 lan ports, but also optimize for ease > of setup/maintenance. > > Any recommendations from those that have already done this? > > Mahalo, > Jeremy > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] > --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
