I seem to be missing something here.
I'm trying to set up a multi-homed WAN set up doing round robin balancing and failover. Here's what I've got: DSL Modem - Modem operates in bridged mode, static IP from ISP. Cable modem - Modem also operates in bridged mode, static IP from the ISP as well. Local NIC - Static IP and to be used to NAT local network across the two WAN's. I am attempting to do this using pfSense 1.2-RC1 and following the guide from here: http://doc.pfsense.org/index.php/MultiWanVersion1.2. After I get the following work done: WAN (DSL): Type - Static IP - ISP provided IP Gateway - ISP provided gateway OPT1 (Cable): Type - Static IP - ISP provided IP Gateway - ISP provided gateway. After I have the interfaces configured I should be ready to move on to create the three needed pools as referenced in the guide above, but here's the problem I run into while creating the first pool: Name: Load Balance Description: Load balance two WAN's Behavior: Load balancing Monitor: First DNS Server Interface: At the interface box is where I have trouble and I can't make progress. >From the drop down list I am only able to select OPT1 and not WAN at all. Now if I disable the OPT1 interface then I can select WAN, but so far it's just OPT1 is all I can access. Am I doing something wrong? Also, some background information on what I'm using here: Dell OptiPlex GX110 512MB of RAM 1GHz P3 140GB IDE Disk 1 Onboard NIC 2 Realtek NIC's pfSense 1.2-RC1 (RC2 and 3 both cause problems at the boot block when installing, so I am sort of stuck here. Any and all help is very much appreciated. Thank you, Thomas
