What do you mean you can't pass traffic? You can't get ICMP off of a wireless client, can't ping the VLAN interface, what?
When I hooked my 1230 directly up to my pfSense system, I couldn't reach VLAN interfaces on the AP, I had to use BVIs. If I may ask, why do you need a layer 3 interface on the AP (other than mgt) anyway? To address Curtis' note, mine is talking on the 'native' VLAN just fine. Correct or not, an excerpt from mine: interface Dot11Radio0 no ip address no ip route-cache no dot11 extension aironet no cdp enable bridge-group 1 bridge-group 1 block-unknown-source no bridge-group 1 source-learning no bridge-group 1 unicast-flooding bridge-group 1 spanning-disabled ! interface Dot11Radio0.20 encapsulation dot1Q 20 no ip route-cache no cdp enable bridge-group 20 bridge-group 20 subscriber-loop-control bridge-group 20 block-unknown-source no bridge-group 20 source-learning no bridge-group 20 unicast-flooding bridge-group 20 spanning-disabled ! interface FastEthernet0 no ip address no ip route-cache duplex auto speed auto no cdp enable bridge-group 1 no bridge-group 1 source-learning bridge-group 1 spanning-disabled ! interface FastEthernet0.20 encapsulation dot1Q 20 no ip route-cache no cdp enable bridge-group 20 no bridge-group 20 source-learning bridge-group 20 spanning-disabled ! interface BVI1 ip address dhcp no ip route-cache ! --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
