What are the rules you are using on the WAN for traffic. Keep in mind when you are defining the destination address it should be the PRIVATE IP not the PUBLIC one
If you are getting the correct address on whatismyip then the NAT mapping is fine. it is firewall rules that are messing you up. -Tim From: Ryan Rodrigue [mailto:[EMAIL PROTECTED] Sent: Wednesday, December 26, 2007 10:27 AM To: [email protected] Subject: RE: [pfSense Support] Virtual Ips I have it setup as Proxy ARP I went to 1:1 NAT and firewall rules and specified the 73 and 72 as two seperate entries using the /32 subnet mask on the WAN interface it is setup as x.x.x.74 /29 I setup a wan rule to allow anything with the destination 192.168.1.10 and same for 192.168.1.100 I can still not get anything to work. I am getting the correct IP address if i go to whatismyip.com, but when i try to hit the webserver ip from my phone (seperate network all together) it doesn't work. I thought this was going to be fairly simple. lol -----Original Message----- From: Curtis LaMasters [mailto:[EMAIL PROTECTED] Sent: Wednesday, December 26, 2007 12:00 PM To: [email protected] Subject: Re: [pfSense Support] Virtual Ips Under Virtual IP's are you using Carp, Proxy Arp, or IP? If you want to use 1:1 NAT, go ahead and do so for that specific IP address, then under the firewall rules add in a rule to match the traffic you would like to permit. It should be that simple. Additionally, the IP's 73 and 72 are within your given range correct? Are you using the correct subnet mask? Curtis
