Galen,
I'm frugal, but I'm also all about easy. I bought a serial cable just
to make everything go smooth. Having done that, I upgraded the
firmware on my Alix board, put RC4 on there, and it booted right up.
Set my interfaces up, and was ready to go. I don't know if this
approach is easier than editing .XML files, but it was pretty cool to
see everything working as advertised, and it speaks to the quality of
the available tutorials.
Aloha,
Jeremy
On Feb 18, 2008, at 11:52 AM, Oliver von Bueren wrote:
[EMAIL PROTECTED] wrote:
I am trying to avoid getting out a serial cable. I need a working
example for a PC Engines board. I have manually changed the
interface names to vr0/vr1/vr2 but I'm still not getting activity.
Can somebody please show me concrete examples of config.xml that
are working for you?
Hi Galen
Is it a very new one? If yes, and it doen't have the latest
firmware on it (v0.99), namely a v0.98 version, the current image
(RC4) will hang during boot. To make sure you have to get your
serial (null-modem) cable up and running. The one shipped to me a
couple of weeks ago had 0.98 on it and therefore did not complete
booting up.
Oliver
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
