On Jul 11, 2008, at 5:22 AM, Paul Mansfield wrote:
Openvpn works perfectly for me on the n800; just be sure you have it
start up when you want it too, as it will start up by default.
I discovered this when I didn't realise it was running, and when I
was actually directly on the network the tunnel would normally
connect to, it all broke!
Thanks! I do need to only turn it on when I'm "away" from one of my
normal locations since they're all already connected via VPN. There's
no end of breakage that happens if you try to set up an IPsec tunnel
from a device to the same endpoint that the router is tunneling the
whole LAN... took several days to figure out that problem! :-(
Which OpenVPN software do you run on your n800? Is it from the maemo
garage or some other place? Or did you build it by hand?
Also, were there any unique configs you had to set up for pfSense or
just the normal OpenVPN setup?
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
