I'm reinstall Pfsense 1.2.2 on Pentium 4, 3.40Ghz (Intel Pentium 4 Northwood/Prescott) however, after a successful installation, it get stuck on boot with "/boot/kernel/acpi.ko" I tried IDE and SATA drives with the same problem.
David Rees suggested the following Try the following: 1. Make sure bios is the latest version. 2. Reset bios to defaults 3. Make sure you're using the latest pfSense. If already trying 1.2.2, give the latest 1.2.3-snapshot a try. And try disabling acpi to see if that helps: http://devwiki.pfsense.org/BootOptions I've tried all but still having the same issue. -----Original Message----- From: Gary Buckmaster [mailto:[email protected]] Sent: Thursday, January 29, 2009 6:21 PM To: [email protected] Subject: Re: [pfSense Support] Stuck on boot k_o_l wrote: > > Can't get further than > > Pfsense/i386 boot > > Default: 0:ad(0,a)/boot/loader > > Boot: > Could you be more specific with your issue? What version of pfSense? What hardware are you using? Is this an install or just a LiveCD? Have you already worked through the Boot Troubleshooting section of the FAQ? --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected] Commercial support available - https://portal.pfsense.org --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected] Commercial support available - https://portal.pfsense.org
