Hello,
I set out tonight to get a new firewall box deployed; this will be the first on
which I am using the VLAN feature in PFSense. I figured I was going to be done
quick; boy was I wrong.
My configuration looks like this:
PFSENSE
[WAN]----[OPT1 (192.168.1.1) (VLAN 101)]----[Cisco 2950]----Laptop
(192.168.1.2) (VLAN 101)
There are other VLANs, but I suspect that is not particularly relevant. My
issue is that I cannot get through the Cisco 2950 when VLAN tagged. If I
connect directly to the PFSense box, everything works exactly as I would have
expected it to.
So clearly, I have not configured the Cisco correctly. I am confused how,
though, because I have performed the following steps on the 2950:
Config t
Interface fastethernet0/6
switchport access vlan 101
exit
Interface fastethernet0/7
switchport access vlan 101
exit
show vlan brief shows that both interfaces are on the correct VLAN, and yet...
I'm still stuck without traffic.
I googled and dove through the forums, and at the end of the day, after 3 hours
of searching, I am posting. Any thoughts? :)
Thank You,
Nathan Eisenberg
Sr. Systems Administrator
Atlas Networks, LLC
Atlas Support Center
http://support.atlasnetworks.us/portal
