On Aug 3, 2009, at 11:32 PM, Aarno Aukia wrote:
As 1.2.3 hasn't been released yet, I assume you are using 1.2.3-rc1.
You said you installed the siproxd package on 1.2.3-rc1 embedded ?
Have you:
- configured siproxd ? services -> siproxd, set the in- and outbound
interfaces, port ranges etc
- added firewall rules to WAN to allow the configured port ranges ?
- configured AON by simply clicking "Manual Outbound NAT rule
generation" in Firewall -> NAT -> Outbound, leaving the default rule
untouched and applying ?
-Aarno
On Tue, Aug 4, 2009 at 11:08, Jeremy Bennett<[email protected]>
wrote:
On Aug 3, 2009, at 6:29 PM, David Burgess wrote:
On Mon, Aug 3, 2009 at 9:55 PM, Jeremy
Bennett<[email protected]>
wrote:
When I install siproxd, everything looks good, however when I go
to my
"services" page and press the "play/start" button, PFsense
reports that
"siproxd has been started", but when the page refreshes, the
status still
shows up as "stopped".
Have you tried refreshing the Services>>Status page after waiting a
few more seconds? I haven't used the siproxd package, but I know
that
some services take longer to start than it does for the page to
refresh.
db
Yes I have waited for 30 seconds, a minute, 5 minutes, It never
changes from
"stopped"
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
Commercial support available - https://portal.pfsense.org
--
Aarno Aukia
Atrila GmbH
Switzerland
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
Commercial support available - https://portal.pfsense.org
Checked through Aarno's suggestions. Was able to get siproxd to
"running" status. Next issue to wade through: My VOIP provider doesn't
use RTP. If I disable RTP in siproxd, it won't run. Does that mean I
am out of luck?
Mahalo,
Jeremy
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
Commercial support available - https://portal.pfsense.org
