hail,
I'm just replacing an OpenBSD router to pfSense, and two things are
missing for now:
this from subject - rue0 is the nic to the modem, and it has no addresses.
I used to have 192.168.253.254 as the modem uses .253. I tried with
virtual ips (as it worked for the lan side) and nothing.
ifconfig shows:
rue0: flags=108843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST,NEEDSGIANT>
metric 0 mtu 1500
ether 00:e0:4c:03:6a:79
inet6 fe80::2e0:4cff:fe03:6a79%rue0 prefixlen 64 scopeid 0x2
media: Ethernet autoselect (100baseTX <full-duplex>)
status: active
and apert from this all is fine. is there a way to do this from webgui ?
(I can ssh to it and chage local.sh in /usr/local/etc/rc.d if is the only
way =] )
and, as I use reu0 and it has no altq functionalities, where there is a
8.0 based snapshot to try on. I have aue nics here that altq work, but
this way 7.x doesn't. must be 8.x (tested already).
thanks,
matheus
--
We will call you cygnus,
The God of balance you shall be
A: Because it messes up the order in which people normally read text.
Q: Why is top-posting such a bad thing?
http://en.wikipedia.org/wiki/Posting_style
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
Commercial support available - https://portal.pfsense.org
