On Jan 31, 2010, at 12:14 PM, Martin Kruse Jensen wrote: > Remko Lodder skrev: >> On Jan 31, 2010, at 11:27 AM, Martin Kruse Jensen wrote: >> >> >> >>> Hi. >>> >>> I'm having some problems setting up NAT when using multiple external >>> adresses (ie. a /29 subnet). I have a WAN interface set up as x.x.x.18/29 >>> but when making NAT rules, I can't select the individual adresses - only >>> "WAN address" or "Any". >>> >>> When attempting to use 1:1 NAT I can't get it to work either - and yes, of >>> course I remembered to add firewall rules ;) >>> >>> Any hints would be appreciated! >>> >>> Regards, >>> Martin Kruse >>> >>> >>> >> >> >> Consult the "Virtual Addresses" please: >> >> " >> The virtual IP addresses defined on this page may be used in NAT mappings. >> You can check the status of your CARP Virtual IPs and interfaces here. >> " >> >> Cheers, >> Remko >> >> >> > I have actually tried setting up "Virtual addresses" but I can't save them - > it fails with the following error: > The following input errors were detected: > > • The MANAGEMENT IP address may not be used in a virtual entry. > > "MANAGEMENT" is the name of my OPT1 interface but when setting up the Virtual > IP I actually selected WAN. > > I should problary mention that i am using 2.0-BETA1 built on Fri Jan 22 > 08:25:58 EST 2010 > > //Martin
Did you try a different IP then the one that is defined on the interface itself? so for starts if you have assigned .1 to the real interface, can you create the .2 ip address as a virtual ip? -- /"\ Best regards, | [email protected] \ / Remko Lodder | re...@efnet X http://www.evilcoder.org/ | / \ ASCII Ribbon Campaign | Against HTML Mail and News --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected] Commercial support available - https://portal.pfsense.org
