On 31/03/2010 19:18, Evgeny Yurchenko wrote:
Brent Clark wrote:
Hiya
d R
I need would like to reset my pfsense to the factory default settings.
How would one setup pfsense via command line to enable access the
webgui.
Kind Regards
Brent Clark
Connect console or ssh to your pfSense and choose option 4)
pfSense console setup
***************************
0) Logout (SSH only)
1) Assign Interfaces
2) Set LAN IP address
3) Reset webConfigurator password
4) Reset to factory defaults
5) Reboot system
6) Halt system
7) Ping host
8) Shell
9) PFtop
10) Filter Logs
11) Restart webConfigurator
12) pfSense Developer Shell
13) Upgrade from console
14) Disable Secure Shell (sshd)
Enter an option:
Thanks for this
But let me try this again ....
What I was refering to and asking for is ... I press 8, what is the
firewall command or the process to allow access to the webgui from the WAN.
I dont have physical access to the machine, but I can access the console
via a DRAC.
Regards
Brent Clark
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
Commercial support available - https://portal.pfsense.org
