On Mon, May 31, 2010 at 1:56 AM, Justin The Cynical <[email protected]> wrote: > Greetings. > > I finally set up a failover box for CARP. And so far, everything seems > to be working fine, with one minor detail. > > WAN IP range: .65 - .96 > > .66 - .68 are setup as CARP > .65 and .69 are the WAN interfaces > Port forwards on .65 and .69 > > The problem: > > When this was a single machine, I had port forwards set up on all the > IP's, and everything was peachy. However, now with multiple machines, > the port forwards on the WAN interfaces will work, depending on the > machine that is active. > > Take a port forward from .65 to internal address (master) > Take a port forward from .69 to internal address (backup) > > The port forward to .65 works, but the .69 does not. If the machines > failover (.69 becomes the active machine), the forward for .69 works, > but the .65 does not. When .65 comes back up as the active box, the > forward on .69 stops working. >
That's just how it works. WAN addresses are usable, but only when that particular box is the master. --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected] Commercial support available - https://portal.pfsense.org
