Thanks Dominic, I have made the same changes at my end...Let me see if these things work for me or not...
On Mon, Aug 30, 2010 at 12:23 PM, Dominic <[email protected]> wrote: > Hi, > > I had a similar issue some time back and landed up finding some > changes required to the > /boot/loader.conf file. I changed it to contain the following and my > browsing / downloads > etc.. went from +/- 100kb/sec to just over 600kb/sec. > > autoboot_delay="3" > > vm.kmem_size="435544320" > > vm.kmem_size_max="535544320" > > #kern.ipc.nmbclusters="0" > > #hint.apic.0.disabled=1 > > kern.hz=100 > > kern.ipc.nmbclusters="32768" > > kern.maxfiles="65536" > > kern.maxfilesperproc="32768" > > net.inet.ip.portrange.last="65535" > > Kind Regards, > > Dominic. > > On Mon, Aug 30, 2010 at 8:34 AM, Abdulrehman <[email protected]> > wrote: > > I have Pfsense 1.2.3 with Squid Stable 2.7.9 on it.I am using squid in > > transparent proxy mode. A few days back, everything was working like > > charm.From past few days, I have experienced following > > > > 1- Whenever I go to Services--->Proxy Server and make any changes in the > > proxy, It takes almot 5 to 10 mins to save the changes and reload the > page > > 2- LAN users are getting slow browsing and poor downloading issues.But if > I > > bypass their IP address from Proxy, then it works fine > > 3- If I remove squid from Pfsense and then check browsing on simple NAT, > it > > is charm... > > > > I have been searching everywhere on the internet. Please suggest what to > > check now... > > > > Regards > > Abdulrehman > > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [email protected] > For additional commands, e-mail: [email protected] > > Commercial support available - https://portal.pfsense.org > > -- Regards Abdulrehman
