Hello Everybody :) I would like to use the LAGG to bond multiple ADSL lines for a faster, more reliable internet access (using LACP). To start with I have 2 PPPoA ADSL Modem/Routers each with an Ethernet LAN interface. So I have plugged both modems into two of my pfSense NICs (lets say em1 and em2) and NIC em0 is my local LAN inside the pfSense box. em1 and em2 both need an IP address to talk to each modem, for example em1 (192.168.1.1/24) > modem 1 (192.168.1.254/24) and em2 (192.168.2.1/24) to modem 2 (192.168.2.254/24).
Once I bond em1 and em2 as LAGG0 they become one virtual interface which I can set as my WAN interface. I'm going to assume at this point that things will stop working because pfSense uses LAGG0 as a single interface with a single IP (obviously) which technically is connected to neither modem? What would be the correct steps for setting this up? pfSense supports 1 WAN interface so how can I assign two physical interfaces IP addresses with default GWs and then bond them in the way I wish to use both Modems/ADSL lines simultaneously? I feel like I'm not far off but need a little push :) -- Regards, James. http://www.jamesbensley.co.cc/ There are 10 kinds of people in the world; Those who understand Vigesimal, and J others...? --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected] Commercial support available - https://portal.pfsense.org
