I will try it tonight and post my results in the morning. Thanks On Fri, Jul 29, 2011 at 7:53 AM, Chris Clark <[email protected]> wrote: > Brian, > Have you tried the method to resolve such an issue described here: > http://forum.pfsense.org/index.php?topic=21194.msg109995#msg109995 ? > If you haven't and have a spare pfSense/FreeBSD box, give it a try. > > -----Original Message----- > From: Brian Henson [mailto:[email protected]] > Sent: Friday, July 29, 2011 2:45 AM > To: [email protected] > Subject: [pfSense Support] Fwd: GB-1200 > > I have a problem booting both 1.2.3 and 2.0 rc3 on the GB-1200. It hangs each > time on Trying to mount root from ufs:/dev/ufs/pfsense0. > below is the boot log up until that point. thank you in advance > > > 1 FreeBSD > 2 FreeBSD > > Boot: 1 > /boot.config: -h > Consoles: serial port > BIOS drive C: is disk0 > BIOS 639kB/129984kB available memory > > FreeBSD/i386 bootstrap loader, Revision 1.1 > (sullrich@FreeBSD_7.2_pfSense_1.2.3_snaps.pfsense.org, Mon Dec 7 > 23:00:35 EST 2009) > Loading /boot/defaults/loader.conf > /boot/kernel/kernel text=0x739788 data=0x13cf6c+0x51c80 / \ Hit [Enter] to > boot immediately, or any other key for command prompt. > Booting [/boot/kernel/kernel]... > Copyright (c) 1992-2009 The FreeBSD Project. > Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 > The Regents of the University of California. All rights reserved. > FreeBSD is a registered trademark of The FreeBSD Foundation. > FreeBSD 7.2-RELEASE-p5 #0: Mon Dec 7 23:21:27 EST 2009 > > sullrich@FreeBSD_7.2_pfSense_1.2.3_snaps.pfsense.org:/usr/obj.pfSense/usr/pfSensesrc/src/sys/pfSense_wrap.7.i386 > Timecounter "i8254" frequency 1193182 Hz quality 0 > CPU: Intel(R) Celeron(TM) CPU 1200MHz (1196.12-MHz 686-class > CPU) > Origin = "GenuineIntel" Id = 0x6b1 Stepping = 1 > Features=0x383f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR,SSE> > real memory = 134152192 (127 MB) > avail memory = 117354496 (111 MB) > wlan: mac acl policy registered > cryptosoft0: <software crypto> on motherboard > padlock0: No ACE support. > acpi0: <IntelR AWRDACPI> on motherboard > acpi0: [ITHREAD] > acpi0: Power Button (fixed) > acpi0: reservation of 0, a0000 (3) failed > acpi0: reservation of 100000, 7ef0000 (3) failed Timecounter "ACPI-fast" > frequency 3579545 Hz quality 1000 > acpi_timer0: <24-bit timer at 3.579545MHz> port 0x4008-0x400b on acpi0 > acpi_button0: <Power Button> on acpi0 > pcib0: <ACPI Host-PCI bridge> port 0xcf8-0xcff,0x4000-0x40f7 on acpi0 > pci0: <ACPI PCI bus> on pcib0 > pcib1: <PCI-PCI bridge> at device 1.0 on pci0 > pci1: <PCI bus> on pcib1 > pcib2: <ACPI PCI-PCI bridge> at device 30.0 on pci0 > pci2: <ACPI PCI bus> on pcib2 > fxp0: <Intel 82559ER Embedded 10/100 Ethernet> port 0xa800-0xa83f mem > 0xd7081000-0xd7081fff,0xd7040000-0xd705ffff irq 12 at device 4.0 on > pci2 > miibus0: <MII bus> on fxp0 > inphy0: <i82555 10/100 media interface> PHY 1 on miibus0 > inphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto > fxp0: Ethernet address: 00:d0:68:04:a4:0e > fxp0: [ITHREAD] > fxp1: <Intel 82559ER Embedded 10/100 Ethernet> port 0xa000-0xa03f mem > 0xd7080000-0xd7080fff,0xd7000000-0xd701ffff irq 11 at device 5.0 on > pci2 > miibus1: <MII bus> on fxp1 > inphy1: <i82555 10/100 media interface> PHY 1 on miibus1 > inphy1: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto > fxp1: Ethernet address: 00:d0:68:04:a4:0f > fxp1: [ITHREAD] > fxp2: <Intel 82559ER Embedded 10/100 Ethernet> port 0xa400-0xa43f mem > 0xd7083000-0xd7083fff,0xd7020000-0xd703ffff irq 10 at device 6.0 on > pci2 > miibus2: <MII bus> on fxp2 > inphy2: <i82555 10/100 media interface> PHY 1 on miibus2 > inphy2: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto > fxp2: Ethernet address: 00:d0:68:04:a4:10 > fxp2: [ITHREAD] > pcib3: <PCI-PCI bridge> at device 7.0 on pci2 > pci3: <PCI bus> on pcib3 > dc0: <Intel 21143 10/100BaseTX> port 0x9000-0x907f mem 0xd6000000-0xd60003ff > irq 10 at device 4.0 on pci3 > miibus3: <MII bus> on dc0 > ukphy0: <Generic IEEE 802.3u media interface> PHY 1 on miibus3 > ukphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto > dc0: Ethernet address: 00:50:c2:11:ff:5f > dc0: [ITHREAD] > dc1: <Intel 21143 10/100BaseTX> port 0x9400-0x947f mem 0xd6001000-0xd60013ff > irq 9 at device 5.0 on pci3 > miibus4: <MII bus> on dc1 > ukphy1: <Generic IEEE 802.3u media interface> PHY 1 on miibus4 > ukphy1: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto > dc1: Ethernet address: 00:50:c2:11:ff:60 > dc1: [ITHREAD] > dc2: <Intel 21143 10/100BaseTX> port 0x9800-0x987f mem 0xd6002000-0xd60023ff > irq 12 at device 6.0 on pci3 > miibus5: <MII bus> on dc2 > ukphy2: <Generic IEEE 802.3u media interface> PHY 1 on miibus5 > ukphy2: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto > dc2: Ethernet address: 00:50:c2:11:ff:61 > dc2: [ITHREAD] > dc3: <Intel 21143 10/100BaseTX> port 0x9c00-0x9c7f mem 0xd6003000-0xd60033ff > irq 11 at device 7.0 on pci3 > miibus6: <MII bus> on dc3 > ukphy3: <Generic IEEE 802.3u media interface> PHY 1 on miibus6 > ukphy3: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto > dc3: Ethernet address: 00:50:c2:11:ff:62 > dc3: [ITHREAD] > fxp3: <Intel 82559ER Embedded 10/100 Ethernet> port 0xac00-0xac3f mem > 0xd7082000-0xd7082fff,0xd7060000-0xd707ffff irq 9 at device 10.0 on > pci2 > miibus7: <MII bus> on fxp3 > inphy3: <i82555 10/100 media interface> PHY 1 on miibus7 > inphy3: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto > fxp3: Ethernet address: 00:d0:68:04:a4:11 > fxp3: [ITHREAD] > isab0: <PCI-ISA bridge> at device 31.0 on pci0 > isa0: <ISA bus> on isab0 > atapci0: <Intel ICH2 UDMA100 controller> port > 0x1f0-0x1f7,0x3f6,0x170-0x177,0x376,0xf000-0xf00f at device 31.1 on > pci0 > ata0: <ATA channel 0> on atapci0 > ata0: [ITHREAD] > ata1: <ATA channel 1> on atapci0 > ata1: [ITHREAD] > uhci0: <Intel 82801BA/BAM (ICH2) USB controller USB-A> port 0xb000-0xb01f irq > 9 at device 31.2 on pci0 > uhci0: [GIANT-LOCKED] > uhci0: [ITHREAD] > usb0: <Intel 82801BA/BAM (ICH2) USB controller USB-A> on uhci0 > usb0: USB revision 1.0 > uhub0: <Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1> on usb0 > uhub0: 2 ports with 2 removable, self powered > uhci1: <Intel 82801BA/BAM (ICH2) USB controller USB-B> port 0xb400-0xb41f irq > 5 at device 31.4 on pci0 > uhci1: [GIANT-LOCKED] > uhci1: [ITHREAD] > usb1: <Intel 82801BA/BAM (ICH2) USB controller USB-B> on uhci1 > usb1: USB revision 1.0 > uhub1: <Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1> on usb1 > uhub1: 2 ports with 2 removable, self powered > acpi_tz0: <Thermal Zone> on acpi0 > speaker0: <PC speaker> port 0x61 on acpi0 > sio0: <16550A-compatible COM port> port 0x2f8-0x2ff irq 3 flags 0x10 on acpi0 > sio0: type 16550A, console > sio0: [FILTER] > sio1: <16550A-compatible COM port> port 0x3f8-0x3ff irq 4 on acpi0 > sio1: type 16550A > sio1: [FILTER] > ppc0: <Parallel port> port > 0x378-0x37f,0x778-0x77b,0xb78-0xb7b,0xf78-0xf7b irq 7 on acpi0 > ppc0: Generic chipset (NIBBLE-only) in COMPATIBLE mode > ppbus0: <Parallel port bus> on ppc0 > ppbus0: [ITHREAD] > ppi0: <Parallel I/O> on ppbus0 > ppc0: [GIANT-LOCKED] > ppc0: [ITHREAD] > cpu0: <ACPI CPU> on acpi0 > acpi_throttle0: <ACPI CPU Throttling> on cpu0 > orm0: <ISA Option ROM> at iomem 0xc8000-0xcbfff pnpid ORM0000 on isa0 > Timecounter "TSC" frequency 1196123955 Hz quality 800 Timecounters tick every > 10.000 msec > IPsec: Initialized Security Association Processing. > ad3: 1911MB <LEXAR ATA FLASH CARD 20070918> at ata1-slave PIO4 > WARNING: Expected rawoffset 0, found 63 > WARNING: Expected rawoffset 0, found 922383 Trying to mount root from > ufs:/dev/ufs/pfsense0 > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [email protected] For additional > commands, e-mail: [email protected] > > Commercial support available - https://portal.pfsense.org > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [email protected] > For additional commands, e-mail: [email protected] > > Commercial support available - https://portal.pfsense.org > >
--------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected] Commercial support available - https://portal.pfsense.org
