I`m sorry, maybe i wasn`t clear... when i said "2 WAN" i mean "1 WAN and 1 OPT1"
LAN = Switch internal network WAN = ADSL OPT1 = CABLE MODEM Everything is working fine, with load balance between the links, redundancy etc... the issue is only with the IP to test if the gateway is up or not (System/Routing/Gateway/Edit/Monitor IP) []`s Diego ----- Original Message ----- From: "Chris Buechler" <[email protected]> To: [email protected] Sent: Wednesday, August 17, 2011 5:42:12 PM Subject: Re: [pfSense Support] Monitor IP in gateway, strange behavior On Wed, Aug 17, 2011 at 5:45 PM, Diego Barrios <[email protected]> wrote: > > Hi folks, > I`m not sure if this could be a bug, but i`ve just installed a new PFSense > 2.0RC3 (latest snapshop) with 3 NICs, 1 LAN + 2 WAN > > When i use the same "monitor IP" on both WANs You can't do that. The GUI prevents configuring that and it works correctly as far as I've seen, the GUI let you configure that? --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected] Commercial support available - https://portal.pfsense.org
