Is it possible to create a ADAT interface for RPi from this information? That would be nice if "someone" did that for us :-)
Bo-Erik -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Dave Malham Sent: den 27 september 2012 15:24 To: Surround Sound discussion group Subject: Re: [Sursound] DIY MADI to ADAT converter - RE: "Digital Amplifiers" (Multichannel Amps with ADAT input) Thanks for pointing this out! What might be interesting to think about w.r.t. RPi's (given the lack of a full TDM type interface) is the possibility of modifying this to an Ethernet to ADAT interface. I haven't studied the design in detail but it might well be possible, given the fact that the MADI physical layer is done via an Ethernet chip, to change the function of the fpga to use an Ethernet stack to ADAT protocol, rather than MADI. Incidentally, someone once published the ADAT protocol after some reverse engineering (ah-hm) but there is much more info at www.wavefrontsemi.com/UserFiles/File/AL_Info/AL31/AppNotes/WavefrontAN3101-10 S-Mux Receiver for ADAT Optical Protocol.pdf and also at https://ackspace.nl/wiki/ADAT_project Dave _______________________________________________ Sursound mailing list [email protected] https://mail.music.vt.edu/mailman/listinfo/sursound
