Chad,
Yes, Mine was a Unix Version. It won't be much longer. Outside of cp and ls
I know very little of Unix. I would like to try to install LINUX on it and
learn. I have serious doubts that I will be able to install Linux on it
without much agony. If you know of people who have been successful on
this box please tell me. Quite frankly, After many hours of trying to find
info on the box, I was almost ready to cut it up and try to put another MB
in it. That nice 400 something watt power supply is too good to waste.
I also tried to access the Fugitsu M2694esa SCSI 1gig hard drive on a
different computer. When I hooked it up to a Pentium box with an Adaptec
2940au and a Seagate 4 gig, the Adaptec reported something about the 2
formatting types were incompatible and data might be corrupt. I then hooked
the drive to the 2940 without the Seagate attached and it was recognized
with "no operating system found". I tried to low level format it with
utility in the 2940 bios. I had no luck there either. The 2940 would
report "no host adapter found" after a few seconds of attempted low level
format. Would you (or anyone) know about this? Is this because it was
originally some special UNIX drive? I am thinking that the drive is just
plain toast at this point. The server itself was a throw away that I felt I
could put back into use. I don't know it's history.
Anyway look for pictures offline shortly and any help is appreciated.
Best Regards,
John
----- Original Message -----
From: Chad Fernandez <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Sunday, January 21, 2001 1:46 PM
Subject: Re: [SURVPC] EISA Configuration Utility for Unisys 486
> John,
>
> I also have a Unisys 486 server. I believe it may even look almost
> identical to yours. Mine is an MPE4668, However. If you could easily
> send a picture of your computer, I would like that. I think yours might
> be the Unix version. Mine was DOS/Netware when I got it.
>
> I can send you, what someone sent me. I think the EISA config utility
> will be the same.
>
> Chad Fernandez
> Michigan, USA
>
> JJG wrote:
> >
> > Hello All,
> > I am looking for the EISA configuration utility for a Unisys UN-6100-b
> > server with a 486dx2 66 motherboard with on board SCSI.
> >
> > The Unisys website has been of no help. Neither has any of the search
> > engines (well at least the found this list). Could anyone anyone point
me
> > in the right direction to download this utility. Even better, Could
anyone
> > just zip it up and email it?
> >
> > TIA,
> > John
>
> To unsubscribe from SURVPC send a message to [EMAIL PROTECTED] with
> unsubscribe SURVPC in the body of the message.
> Also, trim this footer from any quoted replies.
> More info can be found at;
> http://www.softcon.com/archives/SURVPC.html
>
>
To unsubscribe from SURVPC send a message to [EMAIL PROTECTED] with
unsubscribe SURVPC in the body of the message.
Also, trim this footer from any quoted replies.
More info can be found at;
http://www.softcon.com/archives/SURVPC.html
