"Dale Mentzer" <[EMAIL PROTECTED]> wrote: > I have an Evergreen MxPro 200 upgrade chip and would like to install > it on my AMD P166. How do I configure the mobo to work with this > chip. What value do I set the: > > CPU voltage? > > Clock frequency? > > Clock multiplier? > > I have the docs for my mobo so I know how to change the values, I > just need the correct values. Evergreen's site was no help. TIA.
I had a couple of similar CPU upgrades using the IDT WinChip C6 @ 200MHz. These had the CPU on a small adapter board which plugged into a Socket 5 or 7 directly. From what I've read, the Evergreen is similar. It just plugged in place of a P75 or faster, so set your jumpers as if you're using a pre-MMX P75-120. As I recall, clock frequency and multiplier did NOT matter. You'll get an erroneous BIOS reading when you start (not surprising), but benchmarks should confirm things are a bit faster. - Bob To unsubscribe from SURVPC send a message to [EMAIL PROTECTED] with unsubscribe SURVPC in the body of the message. Also, trim this footer from any quoted replies. More info can be found at; http://www.softcon.com/archives/SURVPC.html
