Am 03.09.2014 um 21:44 schrieb Paul Wouters:
could you add -u -v and -e to the initscript and see if you can pinpoint
the problem?
initsystems/sysvinit/init.debian.in has not been changed, so I suspect
something was updated in the debian/ directory.
Paul
bash -x /usr/local/libexec/ipsec/_stackmanager start
+ awk '$1 == "inet" || ($1 == "inet6" && !/ dynamic/) {
cmd = "ip addr add"
if ($1 == "inet")
sub(" [^ ]+:[^ ]+"," ")
sub("secondary","","")
sub("/.*","",$2)
sub("dynamic","")
for (i = 2; i < NF; i++) {
if ($i == "brd" || $i == "peer" || $i ==
"secondary")
i++
else
cmd = cmd " " $i
}
if ($NF != phys)
cmd = cmd " " $NF
cmd = cmd " dev " virt ">/dev/null 2>/dev/null"
system(cmd)
}' phys=eth0 virt=ipsec0
awk: line 5: syntax error at or near
A diff of _stackamanger between 3.9. and 3.10 shows me:
@@ -361,13 +361,14 @@
ipsec tncfg --attach --virtual ${virt} --physical ${phys}
# configure all the IPv4/IPv6 addresses (including
point-to-point)
- ip addr show dev ${phys} | \
+ ip addr show dev ${phys} label ${phys} | \
awk '$1 == "inet" || ($1 == "inet6" && !/ dynamic/) {
- cmd = "ip addr add"
- if ($1 == "inet")
- sub(" [^ ]+:[^ ]+"," ",$0)
+ cmd = "ip addr add"
+ if ($1 == "inet")
+ sub(" [^ ]+:[^ ]+"," ")
+ sub("secondary","","")
sub("/.*","",$2)
- sub("dynamic","",$0)
+ sub("dynamic","")
for (i = 2; i < NF; i++) {
if ($i == "brd" || $i == "peer" || $i ==
"secondary")
i++
@@ -376,9 +377,9 @@
}
if ($NF != phys)
cmd = cmd " " $NF
- cmd = cmd " dev " virt ">/dev/null 2>/dev/null"
- system(cmd)
- }' phys=${phys} virt=${virt}
+ cmd = cmd " dev " virt ">/dev/null 2>/dev/null"
+ system(cmd)
+ }' phys=${phys} virt=${virt}
ip link set up dev ${virt}
if [ "${overridemtu}" != "" ]; then
I'm not a coder, don't know where there's a debian specific error.
Michael
--
www.muenz-it.de
- Cisco, Linux, Networks
_______________________________________________
Swan mailing list
[email protected]
https://lists.libreswan.org/mailman/listinfo/swan
