Hi tobias,

make sure that you only put the physical interfaces into portchannel, 
rest of the config  is done on your portchannel.
It get's replicated to the physical interfaces.
If you change something directly on the gig he will bring down the
etherchannel :/
(complain about different configuration between portchan and gig)

-steven

> -----Ursprüngliche Nachricht-----
> Von: [email protected] [mailto:swinog-
> [email protected]] Im Auftrag von Tobias Brunner
> Gesendet: Dienstag, 3. April 2012 09:24
> An: Swinog
> Betreff: [swinog] EtherChannel - Long Time between LINK-3-UPDOWN and
> LINEPROTO-5-UPDOWN
> 
> Hi there,
> 
> Maybe there are some Cisco specialists reading this List =)
> 
> On a WS-C3750X it tooks about 1 minute after connecting a port to change
> the status from LINK-3-UPDOWN "up" to LINEPROTO-5-UPDOWN "up"
> 
> Mar 27 16:25:37 192.168.1.144 788: *Mar  8 00:30:48.032: %LINK-3-UPDOWN:
> Interface GigabitEthernet1/0/1, changed state to up Mar 27 16:26:38
> 192.168.1.144 790: *Mar  8 00:31:49.227: %LINEPROTO-5-UPDOWN:
> Line protocol on Interface GigabitEthernet1/0/1, changed state to up
> 
> Mar 27 16:25:54 192.168.1.144 789: *Mar  8 00:31:05.086: %LINK-3-UPDOWN:
> Interface GigabitEthernet2/0/1, changed state to up Mar 27 16:26:56
> 192.168.1.144 791: *Mar  8 00:32:06.583: %LINEPROTO-5-UPDOWN:
> Line protocol on Interface GigabitEthernet2/0/1, changed state to up
> 
> 
> The ports are configured like that:
> 
> interface GigabitEthernet1/0/1
>  switchport access vlan 27
>  switchport mode access
>  spanning-tree portfast
>  spanning-tree bpdufilter enable
>  channel-group 1 mode active
> !
> interface GigabitEthernet2/0/1
>  switchport access vlan 27
>  switchport mode access
>  spanning-tree portfast
>  spanning-tree bpdufilter enable
>  channel-group 1 mode active
> !
> interface Port-channel1
>  switchport access vlan 27
>  switchport mode access
> end
> 
> The server which is connected has nothing special configured... It should
> boot via DHCP/PXE (of course without Bonding) and then the installed Linux
> with Bonding configured.
> Does anyone have an idea why this takes so long?
> 
> Thanks!
> 
> Cheers,
> Tobias
> 
> --
> Nine Internet Solutions AG, Albisriederstr. 243a, CH-8047 Zuerich Support
+41
> 44 637 40 40 | Tel +41 44 637 40 00 | Direct +41 44 637 40 13 Skype
> nine.ch_support
> 
> 
> _______________________________________________
> swinog mailing list
> [email protected]
> http://lists.swinog.ch/cgi-bin/mailman/listinfo/swinog



_______________________________________________
swinog mailing list
[email protected]
http://lists.swinog.ch/cgi-bin/mailman/listinfo/swinog

Antwort per Email an