Hi, This delay is introduced by the underlying transport used by Synapse. That transport takes about 60 seconds to report the failure of the target endpoint. Loadbalancer takes action to remove the failed endpoint and send requests to remaining endpoints only after the failure is reported. Currently there is no way to configure the time taken to detect the failure at the transport level.
Although this is not related to the problem, you are using failover="false" attribute in your load balance configuration. This will cause lose of messages, sent to the failed endpoint, while it is detected as failed. If you want to resend such messages to remaining endpoints, use failover="true" or remove the failover attribute, which defaults to true. Thanks, Chathura On 9/13/07, bvalentine1 <[EMAIL PROTECTED]> wrote: > > > Hello, > > We want to load balance requests through Synapse but after shutting down 1 > of the 3 endpoints, no more requests are recieved by our endpoints for > about > 60 seconds. > > Is this configurable or a symptom of a bad configuration? > > Here is the config: > > <definitions xmlns="http://ws.apache.org/ns/synapse";> > > <sequence name="main" onError="errorHandler"> > <in> > <send> > <endpoint> > <loadbalance failover="false"> > <endpoint> > <address > uri="http://localhost:7010/wsProvider/webservice/wsProvider";> > > <suspendDurationOnFailure>30</suspendDurationOnFailure> > <timeout> > <duration>3</duration> > <action>fault</action> > </timeout> > </address> > </endpoint> > <endpoint> > <address > uri="http://localhost:7015/wsProvider/webservice/wsProvider";> > > <suspendDurationOnFailure>30</suspendDurationOnFailure> > <timeout> > <duration>3</duration> > <action>fault</action> > </timeout> > </address> > </endpoint> > <endpoint> > <address > uri="http://localhost:7020/wsProvider/webservice/wsProvider";> > > <suspendDurationOnFailure>30</suspendDurationOnFailure> > <timeout> > <duration>3</duration> > <action>fault</action> > </timeout> > </address> > </endpoint> > </loadbalance> > </endpoint> > </send> > </in> > > <out> > <send/> > </out> > </sequence> > > <sequence name="errorHandler"> > > <makefault> > <code value="tns:Receiver" > xmlns:tns="http://www.w3.org/2003/05/soap-envelope"/> > <reason value="COULDN'T SEND THE MESSAGE TO THE SERVER."/> > </makefault> > > <header name="To" action="remove"/> > <property name="RESPONSE" value="true"/> > > <send/> > </sequence> > > </definitions> > > > Thanks for the help > > > > -- > View this message in context: > http://www.nabble.com/Load-Balancing%3A-Clients-wait-60-seconds-after-1-of-3-endpoints-shut-down-tf4431948.html#a12643882 > Sent from the Synapse - User mailing list archive at Nabble.com. > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] > >
