Hi,  can you help me??

i have a problem with synce under SuSE 10 to sync my pda with USB. 

no connect to the pda.

my Kernel Version: 2.6.13-15-default

my output from the USB Device:

32c32,40
< T:  Bus=02 Lev=02 Prnt=03 Port=03 Cnt=01 Dev#=  4 Spd=12  MxCh= 0
---
> T:  Bus=02 Lev=02 Prnt=03 Port=00 Cnt=01 Dev#= 12 Spd=12  MxCh= 0
> D:  Ver= 1.00 Cls=ff(vend.) Sub=ff Prot=ff MxPS=16 #Cfgs=  1
> P:  Vendor=03f0 ProdID=1016 Rev= 0.00
> C:* #Ifs= 1 Cfg#= 1 Atr=80 MxPwr= 50mA
> I:  If#= 0 Alt= 0 #EPs= 2 Cls=ff(vend.) Sub=ff Prot=ff Driver=ipaq
> E:  Ad=81(I) Atr=02(Bulk) MxPS=  64 Ivl=0ms
> E:  Ad=04(O) Atr=02(Bulk) MxPS=  64 Ivl=0ms
>
> T:  Bus=02 Lev=02 Prnt=03 Port=03 Cnt=02 Dev#=  4 Spd=12  MxCh= 0

----------
please, i need a full introduction to config synce under suse 10. 

the synce applet is the packet from suse 10 (version 0.8.0-6)

my pda is a HP IPAQ rz1710 with pocket pc 2003 pro and a USB sync cable

thx and bye

Manuel Dirksen

(can you send me the introdution in german???    it´s better for me ;-)
my english is not soo perfect ;-)


-------------------------------------------------------
This SF.Net email is sponsored by:
Power Architecture Resource Center: Free content, downloads, discussions,
and more. http://solutions.newsforge.com/ibmarch.tmpl
_______________________________________________
Synce-devel mailing list
[EMAIL PROTECTED]
https://lists.sourceforge.net/lists/listinfo/synce-devel

Reply via email to