Bugs item #1876919, was opened at 2008-01-22 00:28 Message generated for change (Tracker Item Submitted) made by Item Submitter You can respond by visiting: https://sourceforge.net/tracker/?func=detail&atid=757416&aid=1876919&group_id=144022
Please note that this message will contain a full copy of the comment thread, including the initial issue submission, for this request, not just the latest update. Category: None Group: None Status: Open Resolution: None Priority: 5 Private: No Submitted By: Genete (genete) Assigned to: Nobody/Anonymous (nobody) Summary: Modify a parameter in non animation mode is weird. Initial Comment: 1)File -> new (set time bigger than 0) 2)Add any type of layer 3)Change to animation mode 4) modify any parameter (add a waypoint) Let's call the modified parameter value "A" 5) Set non animation mode. 6) Modify again the same parameter (it would complain about being in non animation mode) let's say the modified parameter value is "B". It is reverted to be "A" again. 7) Immediately set it to animation mode. It stills being "A" 8) Click on any parameter (the same or other) and the parameter holding "A" value becomes to be "B" value. ---------------------------------------------------------------------- You can respond by visiting: https://sourceforge.net/tracker/?func=detail&atid=757416&aid=1876919&group_id=144022 ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Synfig-devl mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/synfig-devl
