Ok, changed to octets. Anton.
> -----Original Message----- > From: Sam Hartman [mailto:[EMAIL PROTECTED] > Sent: Tuesday, November 08, 2005 9:11 PM > To: Anton Okmianski (aokmians) > Cc: [EMAIL PROTECTED] > Subject: Re: [Syslog] Comments on syslog udp transport 05 > > >>>>> "Anton" == Anton Okmianski (aokmians) > <[EMAIL PROTECTED]> writes: > > Anton> Section 2 on Terms has this: > > Anton> "The words 'byte' and 'octet' are used interchangeably in > Anton> this document.". > > I did see that. > > Anton> I can change it to: > > Anton> "The words 'byte' and 'octet' are used interchangeably in > Anton> this document to refer to an octet.". > > Anton> Is this sufficient? > > No, I'm not really happy with that. The IETf tends to use > octet in specs we publish. > > Anton> I'd prefer to stick to byte (after properly defining it as > Anton> octet) since this is what most engineers use and how most > Anton> product documentation is written. If you insist, I can > Anton> switch. > > I'm not sure I quite insist, but I'd strongly request at least. > _______________________________________________ Syslog mailing list Syslog@lists.ietf.org https://www1.ietf.org/mailman/listinfo/syslog