Hi, I'm trying to customize systemd to start/stop network interfaces in an embedded system (OpenEmbedded/Angstrom). Angstrom has some support for systemd and its working fairly well so far. Are there any examples I can start with? Basically, when a network device is installed (USB), I'd like to run "ifup eth0", etc.
this is what I have so far: [Unit] Description=Start networking services After=syslog.target [Service] ExecStart=/sbin/ifup eth0 Type=oneshot ExecStop=/sbin/ifdown eth0 StandardOutput=syslog+console [Install] WantedBy=multi-user.target but its not working: systemctl start network.service asix 1-2:1.0: eth0: link up, 100Mbps, full-duplex, lpa 0xCDE1 ifup[756]: udhcpc (v1.18.5) started ifup[756]: Sending discover... ifup[756]: Sending select for 192.168.1.100... ifup[756]: Lease of 192.168.1.100 obtained, lease time 3600 ifup[756]: adding dns 192.168.1.1 This all looks good, but then when I do ifconfig, the network devices is not configured: root@cm-x270:/lib/systemd/system# ifconfig lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 inet6 addr: ::1/128 Scope:Host UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:4 errors:0 dropped:0 overruns:0 frame:0 TX packets:4 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:268 (268.0 B) TX bytes:268 (268.0 B) running ifup eth0 manually works fine. Beyond this, it would be nice to somehow trigger on when a USB NIC is installed and automatically run ifup. Any pointers would be appreciated. Thanks, Cliff -- ================= http://bec-systems.com _______________________________________________ systemd-devel mailing list systemd-devel@lists.freedesktop.org http://lists.freedesktop.org/mailman/listinfo/systemd-devel