This is cool! Currently I have 8 beaglebone blacks and a small Atom blade as the introducer and helper. I am looking for people to connect to my grid for testing. I even took the hard drive out of the introducer and one node formated them and put tahoe 1.10 i was able to repair the grid no prob.
On 16/10/13 01:28:54, Garonda Rodian <[email protected]> wrote: >My ODROID-U2, Debian Wheezy, LXFE has successfully arrived, booted from >MicroSD, and run. > >python setup.py build failed just after it didn't find tahoe-deps, until I >installed my usual set of packages (including, but not limited to, >python-dev), after which it worked fine. > >python setup.py trial succeed with 6 skipped and 2 expected failures in >something over 1500 seconds, typically using 100% of one out of four cores, >and the maximum amount of total RAM in use I happened to see (htop) was on the >order of 561MB - since it has 2GB of RAM, that's more than fine. > >Further testing to follow - I have high hopes it can serve as an introducer + >storage nodes, or even a helper/client gateway. If I can get a Gigabit USB2 >card working, perhaps it'll even break the 10MB/s limit as a storage node! > >_______________________________________________ >tahoe-dev mailing list >[email protected] >https://tahoe-lafs.org/cgi-bin/mailman/listinfo/tahoe-dev
_______________________________________________ tahoe-dev mailing list [email protected] https://tahoe-lafs.org/cgi-bin/mailman/listinfo/tahoe-dev
