Mojgan wrote: “New detected address ranges are displayed onto 10 meter shifted line of OSM road segment.”
For what it's worth… when implementing the Karlsruhe schema in Canvec data, the interpolation lines were located at 20 meters for tertiary and higher road classification, and 15 meters for lower classification. These values were requested by the community but for aesthetic purposes only. Daniel From: Mojgan Jadidi [mailto:[email protected]] Sent: February-10-16 09:25 To: [email protected] Subject: Re: [Talk-ca] Bulk Import of Address Range in GTHA from Metrolinx, Second attemps Hi all, As you can find in our wikipage, we resolve the issue of licensing by using Open Government data portal which use Open Government License-Canada accepted by OSM. StatCan 2015 road network is part of this portal. For accuracy and consistency issue, as I mentioned we validate our result with imagery data and geosbase road segment geometry following with an extensive visual inspection. Our visual inspection is on-going step and never stops!. I would like to emphasize that we checked OSM address ranges against StatCan road segment by buffering left and right, if there is not enough address we extract from StatCan and complete OSM address ranges. New detected address ranges are displayed onto 10 meter shifted line of OSM road segment. We are going to check again for short address ranges and replace with node address! Thanks for your support Mojgan Mojgan (Amaneh) Jadidi, Ph.D. Intern, Applied Research & Corporate Monitoring Planning & Policy | Metrolinx | 97 Front Street West, Toronto, ON, M5J 1E6 | T: 416-202-5844<tel:416-202-5844> Postdoctoral Research Fellow GeoICT Lab | York University | 4700 Keele St, Toronto, ON, M3J 1P3
_______________________________________________ Talk-ca mailing list [email protected] https://lists.openstreetmap.org/listinfo/talk-ca
