#conf t (conf)#int Gi1/0/1 (conf-int)#switchport trunk encapsulation dot1q (ISL if you must) (conf-int)#no switchport access vlan (conf-int)#swichport trunk native vlan xx (conf-int)#switchport mode trunk
On Wed, Aug 18, 2010 at 11:43 AM, John Pearson <[email protected]>wrote: > Hi, > > > > I want to configure a port on a managed switch to trunk. Right now, the > port is set up on a workstation VLAN. The switch is a 3560G Cisco. I am > drawing a blank with my resources. > > > > Thanks in advance. > > > > Mr. John E. Pearson > > Tri-Valley CUSD #3 Technology Director > > 503 E. Washington St. > > Downs, IL 61736 > > (309) 826-7218 > > http://www.tri-valley3.org > > [image: Description: viking] > > > > | Subscription info at http://www.tech-geeks.org | > -- -- Ben Story CCSP, CCNA, CCNA Wireless, CCDA [email protected] "You cannot escape the responsibility of tomorrow by evading it today. -- Abraham Lincoln
<<image001.gif>>
| Subscription info at http://www.tech-geeks.org |
