On Fri, 18 Oct 2013 15:50:55 +0200 Edgar Fuß <[email protected]> wrote:
> The man page says: > > The stripe units per parity unit and stripe units per reconstruction > unit are normally each set to 1. While certain values above 1 are > permitted, a discussion of valid values and the consequences of using > anything other than 1 are outside the scope of this document. > > I noticed that reconstruction seems to read/write in units of one > stripe unit, which in my case (being 4k) seems rather inefficient. Is > it possible to accelerate recontruction by using a figure larger than > 1 here? If you go here: http://www.pdl.cmu.edu/RAIDframe/ and pull down the "RAIDframe Manual" and go to page 73 of that manual you will find: "When specifying SUsPerRU, set the number to 1 unless you are specifically implementing reconstruction under parity declustering; if so, you should read through the reconstruction code first." The answer might be "yes", but I don't know what the other implications are. I'd only recommend changing this value on a RAID set you don't care about, with data you don't care about. I'd also recommend reading through the reconstruction code, looking for "SUsPerRU"... Later... Greg Oster
