On 2012/05/05 16:14, Sebastian Benoit wrote: > Index: relayd.conf.5 > =================================================================== > RCS file: /opt/OpenBSD-CVS/src/usr.sbin/relayd/relayd.conf.5,v > retrieving revision 1.127 > diff -u -p -r1.127 relayd.conf.5 > --- relayd.conf.5 24 Apr 2012 14:56:09 -0000 1.127 > +++ relayd.conf.5 5 May 2012 13:59:19 -0000 > @@ -385,16 +385,18 @@ host from the specified table: > .Bl -tag -width Ds > .It Ic mode hash > Balances the outgoing connections across the active hosts based on the > -hashed name of the table. > -Additional input can be fed into the hash by looking at HTTP > -headers and GET variables; see the > +hashed name of the relay, the hashed name of the the table and the ip
IP should be in upper-case, and repeated 'the the'. > +address and port of the relay. > +Additional input can be fed into the > +hash by looking at HTTP headers and GET variables; > +see the > .Sx PROTOCOLS > section below. > This mode is only supported by relays. > .It Ic mode loadbalance > Balances the outgoing connections across the active hosts based on the > -hashed name of the table, the source and destination addresses, > -and the corresponding ports. > +hashed name of the relay, the hashed name of the the table, the ip same here. > +address and port of the relay and the source address of the client. For consistency I think I would prefer "IP address" rather than "source address" here. > This mode is only supported by relays. > .It Ic mode roundrobin > Distributes the outgoing connections using a round-robin scheduler Otherwise OK with me.
