On 15 Jun 2013 16:34 , Markus Schatzl wrote:
... 
> the gpios for the 6501 work. At least "set out". "set in"
> doesn't as far as I can see now:
> 
>  starting pre-securelevel daemons:gpioctl: GPIOPINSET: Operation
>  not supported by device
>  gpioctl: GPIOPINSET: Operation not supported by device
> 
> I have to check this in more detail with a scope, but I can
> switch my fan on and off with sensorsd now, which is cool.

I have to revise the above statement, it's just the additional
modifiers that don't work.

All 16 GPIO pins on gpio0 work as expected as "in" and "out", 
however exclusively with those two. Any other modifier flags 
are not working.

Voltage on output pins is 3.3 V.

Regards,
/Markus

Reply via email to