On 09/03/16 13:55, Aaron Riekenberg wrote:
I have been using a 5.9 amd64 box with 2 em interfaces configured as a
bridge for some time between my ISP's modem/router and my home network.
With this setup on 5.9, things worked perfectly.
On 6.0 I have tried the same very simple configuration of creating a bridge
with em0 and em1 interfaces and passing all traffic (see configuration
below). With 6.0 this is unstable - clients are often unable to obtain a
dhcp lease from the router through the bridge, which makes the it
unusable. If I remove the openbsd 6 bridge from my network and replace it
with a simple cable, things work fine again.
Did something change or break with bridge in 6.0?
Yes something changed. That might be the cause for your regression.
Sadly your bug report does not contain enough information for us to
figure out. What is your whole config: dmesg, routing table, hostname*
Do you run dhclient on your bridge or any of its interface?
And please next time send bug reports to bugs@ :)
