On 3.7.2017. 23:42, Stuart Henderson wrote:
> The phrase "break sequence" is often used, but it's a bit of a misnomer.
> When a serial port is connected but not actively transmitting data the tx
> line is usually held high. A "break" is when that line is low for more 
> than a frame duration (the length of which depends on the port speed).
> 
> If the tx line is only being held low for a short time during reboot,
> I wonder if you might get lucky by selecting a lower port speed.
> (Avoid going too low, especially if you have enabled extra debug
> messages, or it's likely to interfere with other kernel operations
> while it's printing to the console.)

Yes, on 38400 everything seems fine ....

Thank you for nice info ...


Reply via email to