RCA PTK195AB , P52810LV projo instantly blows 5A AC fuse

cust called ,said it started looking distorted,so he turned it off.Later
it was totally dead. Sure enough. In the shop I found the main 5 amp AC
fuse blown. No shorts found. Q14401 HOT OK, main v. regulator Q14101 OK.
PS Rectifiers all seem OK.Rectifier bridge OK. Main capacitor
[EMAIL PROTECTED] OK. BUT: Install a new 5A fuse ,simply plugping in the line
cord instantly blows fuse. No shorts found
Replace the Convergence power supply board (mounted  above Converegence
amp board) #205686 @$30 us Also  remove bottom tuner cover and resolder
all ground points  and surrounding surface mounted caps .
==================================
RCA PTK195AB ,P52810LV projo instantly blows 5A AC fuse

Unplug the AC cable near AC input that goes up to this board (red and
black wires) replace line fuse and see if set turns on you won't have
any convergence if turns on ok replace board or troubleshoot GL "joe"
==================================
[EMAIL PROTECTED] From: [EMAIL PROTECTED]
(Intrepid�Video�Support) Date: Fri, Jan 30, 2004, 9:56am To:
[EMAIL PROTECTED] (Tech List) Subject: [Techs] TA RCA
P52812AB(PTK195AB)Dead..Was conver. issue Reply�to:
[EMAIL PROTECTED] (ELECTRONICS PROFESSIONALS LIST)
I had a call originally on this for convergence going out after 30-60
minutes. Replaced STK IC U19700 and open R19233 (15K-3w). After
replacing these, the set is dead...I double checked every connector many
times and can not find the problem.
S/B voltages seem find(no print)..Best I can do from my notes is, pin 5
of micro has 2.5v, press power, goes to 0 v.
U14701 has B+, but 0v on either output. Replaced and still 0v..I
disconnected the output from circuit and still 0v, replaced, same
problem..
I measured these pins as I pressed power and the 5 volts for the output
comes up, but the 12v goes to a couple volts, then to 0.
I've tried the troubleshooting guides, with no luck...or they don't
apply to this set. I am still at a loss what could have happened from
the time I ordered these convergence parts and replaced them..any ideas?
Thank you.
Jeff Dougherty
Intrepid Video TV/VCR
263 S Front St
Steelton PA 17113
fax...717-564-4952
www.intrepid-video.com www.tech-repair.net
______________________________________________
Techs mailing list
[EMAIL PROTECTED]
http://intrepid-video.com/mailman/listinfo/techs_intrepid-video.com

Joes....Electronics
�(Joe:Tech/2004)
[EMAIL PROTECTED]
Fax::509-479-2283


_______________________________________________
Tech Repair CD...order your just $49.00 plus shipping...One year of updates free.
www.intrepid-video.com www.tech-repair.net
Techs mailing list
[EMAIL PROTECTED]
http://intrepid-video.com/mailman/listinfo/techs_intrepid-video.com

Reply via email to