As you know, the new PCE sets use a T10 torx on a long shaft to remove the dratted screws. Since this driver is only available from PCE, ( They get them made by Xcelite) here is how to make your own. Go to the local "Dollar Store" and buy a long screwdriver. Don't matter which tip it has. ( cost 1.00) Go to your local pawn shop and get a T10 torx. (appx cost. .25-.50) Hacksaw off the end of the screwdriver and the shaft of the T10. Weld together and you are set!
Now before you are welding this up, Be sure to get a 2nd long "Dollar Store" screwdriver. This time get a Phillips tip and a 3# drywall screw. Weld the drywall screw to the end of the Phillips screwdriver. It can be done! Just do it carefully. Now some might think this is a long corkscrew- and it would probably work for that, but it's real purpose is to put thru a hole drilled in the floor, then you can "thread" it into coax or other wiring and easily pull them up thru the hole. (Thanks to Bob here for this tip. I made him one and it worked great!) HTH Frank -- HQ Electronics 218 N 1st St Shelton WA 98584 360-426-3336 (Shared phone and fax) http://www.hqelec.com --- Outgoing mail is certified Virus Free. Checked by AVG anti-virus system (http://www.grisoft.com). Version: 6.0.707 / Virus Database: 463 - Release Date: 6/15/2004 _______________________________________________ Tech Repair CD...order your just $49.00 plus shipping...One year of updates free. www.intrepid-video.com www.tech-repair.net Techs mailing list [EMAIL PROTECTED] http://intrepid-video.com/mailman/listinfo/techs_intrepid-video.com
