Does anybody know what it means when an 8K behaves this way?: 1) Powers on 2) All RF/signal LEDs are lit 3) Run LED is blinking 4) There is an ethernet link 5) Nothing else works (doesn't respond to 192.168.254.251 on LAN side, won't attach to network, etc.)
Before these symptoms occurred, we did notice some already odd behavior by this particular unit. I had attempted to change the "Auto-Rescan Duration" value on the eNB Settings tab from 0 to 15. After clicking "Save & Apply", the CPE's web server crashed. So I SSH'd into the thing and issued a manual reboot. After it came back up on the network, I discovered it had forgotten all of its settings and reset to defaults. Logging in and attempting to reconfigure it (via uploading a standard configuration template file that we use for all CPE8Ks at Maintenance > Config Management > Restore Configuration) caused the web server to again crash out, but because I had not re-enabled SSH manually before doing so, I was unable to get into it remotely to reboot it a second time. (It was still attached to the network and passing data just fine, however, so the customer was not off-line). It sat that way until we sent a tech out to reboot it and check things out. He went in to enable SSH access, hit Save & Apply, and the web server *again* became unresponsive. But this time, after powercycling it, it came up into the vegetative state that it still remains in (described at the beginning). Anybody else seen anything like this? -- Nathan _______________________________________________ Telrad mailing list [email protected] http://lists.wispa.org/mailman/listinfo/telrad
