Thanks Andre for finding the font. I will see how can i use that. As you suggested using coreldraw, i don't have this software, i will try to see if i can use some other software like MS word.
I was asking how to extract license plate from image. What I am doing, i get the image, re-sized, convert to binary image and then run the sobel edge filter. So now i have an image that shows me the rectangle part of LP clearly, and I know the ration of height to width is 1 to 2. I just need to scan the image and look for rectangle and calculate their ration, to get the correct LP from image, or is there any other more efficient way. I hope this clear things, if not, I will send you the image as input image and after edge filter image. Zia On Jul 31, 9:10 pm, Andres <[email protected]> wrote: > > Anyway, any of you have any idea, about scanning image and getting the > >> LP (image was filtered using edge filter, i can see the rectangle box > >> of LP, just need to figure out, how to scan and how to extract. The > >> ratio of CA LP is 1 to 2, or 6 to 12 inches (height=6, width=12) > > >> I'm not sure about being understanding completelly. Could you extend a > > little ? -- You received this message because you are subscribed to the Google Groups "tesseract-ocr" group. To post to this group, send email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/tesseract-ocr?hl=en.
