Al, Thanks for the info. I had just reinstalled MixW because the last time I calibrated the soundcard to WWV, it totally trashed the reliability factor that I was enjoying before the calibration. I am running a new installation, and it is since the new install that it has been seen on my transmission. I will do the soundcard calibration again, and hope for the best. At least you tied it all together for me, as far as the correlation between sound card calibration and the no-space syndrome. Thanks, David KD4NUE / AAR4IE GA Army MARS
-----Original Message----- From: [email protected] [mailto:[EMAIL PROTECTED] On Behalf Of w8aii_aar5th Sent: Monday, April 02, 2007 12:47 PM To: [email protected] Subject: [MixW Multimode] Re: Words run together on MT-63 from Some Stations. Hi Dave... The problem that you are experiencing is most likely related to a soundcard calibration issue. MT63 is very critical to soundcard calibration. If you are copying some stations but others are running together, the only way you will know for sure is to check your calibration against WWV. MixW lets you check the "receive" calibration by using SSTV and WWV. If you tune to WWV in SSTV mode look at your verticle line on the screen. If this line slants either way, your receive soundcard calibration is off. You can adjust it easily enough by using the left and right arrow keys until you get as close to vertical a line as possible. Once you get your WWV signal line vertical, you apply the settings to the software. This procedure is explained within the MixW software under "soundcard calibration". This procedure "only" adjusts your "receive" and not the "transmit". You will need to use another program called "CheckSR" to adjust the transmit side of the software... Also, remember, it might not be your station that is out of calibration... It could be the transmitting station... It's best to check yours and make sure you're in calibration... 73 Al, W8AII/ AAR5TH Ohio Army MARS In themixwgroup@ <mailto:themixwgroup%40yahoogroups.com> yahoogroups.com, "David Little" > <dalite01@> wrote: > > > > I have been successful in sending and receiving text on MT-63. > > > > On some stations, I notice the text runs together without any spaces. > > Both typed in and cut and paste. > > > > I am running version 2.1.8 registerred. > > > > Any suggestions? > > > > Thanks > > David > > KD4NUE > > AAR4IE GA Army MARS > > >
