Hello, I will study your special documentation. When I do my test, (adding break command on map block) may be I badly write the "break", I'm not sure now. Because Therion say it didn't know this command. I will try again. After my holidays,
Thanks, Gilbert Stacho Mudrak a écrit : > Gilbert Fernandes (mailinglist) wrote: >> On extend maps, can you add to the join section the break command. >> On plan maps, we can specifie for different scraps the upper and lower >> putting âbreakâ between the join commands. >> Itâs refused for extended maps. > > ??? I am sorry, I do not understand. Normally, break is inserted in the > map and when this map is selected for output, these breaks are not > ignored. Could you please send me some (minimal) sample, where this > problem occurs - i.e. plan where it works and xelev, where it is refused. > >> The best thing will be to be able to position manually an extended scrap >> on the map (relatively to an other), as we can do it for none scraps. >> So we could avoid this problems. > > It can be done using maps, at least I think. > > Example: > > Add to the source code: > > map my_map > scrap1 > break > scrap2 > endmap > > And to the thconfig: > > select my_map > export map -proj extended > > ... and it should work. If there is some problem - just send me some > small example and I can show you how it works (or may be there is some > bug and it does not work.) Or may be I do not understand your problem? > > Regards, S. > > _______________________________________________ > Therion mailing list > Therion at speleo.sk > http://www.speleo.sk/mailman/listinfo/therion >
