Oh, that`s very good Bruce, thanks a lot! Markus
Von: Therion [mailto:[email protected]] Im Auftrag von Bruce Mutton via Therion Gesendet: Dienstag, 28. August 2018 21:19 An: 'List for Therion users' Cc: Bruce Mutton Betreff: [Therion] extention at the rear of the Distox Markus You might find the attached quick reference sheet helpful. Regarding adjustment of measurements in Therion, if you happen to have uncorrected disto measurements, you can use the calibrate statement to amend all measurements in a particular survey with a single short line. calibrate <quantity list> <zero error> [<scale>] ▷ set the instrument calibration. The measured value is calculated using the following formula: measured value = (read value - zero error) × scale. The supported quantities are the same as sd. ie length, tape, bearing, compass, gradient, clino, counter, depth, x, y, z, position, easting, dx, northing, dy, altitude, dz Bruce From: Therion <[email protected]> On Behalf Of Martin Sluka via Therion Sent: Wednesday, 29 August 2018 01:16 To: List for Therion users <[email protected]> Cc: Martin Sluka <[email protected]> Subject: Re: [Therion] extention at the rear of the Distox Device Information The FUNC key can be used to show a sequence of information screens. FUNC key in idle mode shows the first screen. FUNC again navigates from one screen to the next. Use the SMART key to return to the previous screen. Screen 4: Endpiece Offset Shows the actual endpiece offset in mm (-128 - 127). To change the level first press the PLUS and MINUS keys for 2 seconds to allow editing. Then press the PLUS or MINUS key to change the value. Changing the offset is useful for self-made endpieces or other cases where a non-standard reference is used. M. 28. 8. 2018 v 14:48, Markus Boldt via Therion <[email protected]>: Hi, Evaristo and Martin have showed extentions for the Distox. It is a very good Idea. But what is with the so extended length of the distance? Must I change all measurings by hand in the list of Pockettopo or Topodroid or is there a possibility to “say” that to the distox by default? Thanks for the answers. Regards Markus BTW: The meeting at Ebensee was very good and interesting for me as a “only” user. _______________________________________________ Therion mailing list <mailto:[email protected]> [email protected] <https://mailman.speleo.sk/listinfo/therion> https://mailman.speleo.sk/listinfo/therion
_______________________________________________ Therion mailing list [email protected] https://mailman.speleo.sk/listinfo/therion
