Again, I am not sure what your objective is with regards to phase noise performance, but, remember that within the loops BW you will get the phase noise of the source. In this case the GPS. The phase noise spectral density will be modified by the loop's roll-off and then outside of the loop it will be that of the 10811A. - Mike
Mike B. Feher, N4FS 89 Arnold Blvd. Howell, NJ, 07731 732-886-5960 -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Dr. David Kirkby Sent: Tuesday, April 26, 2005 10:46 AM To: Discussion of precise time and frequency measurement Subject: Re: [time-nuts] Brooks Shera's GPS standard or HP Z3801A?? 6) Finally add a GPS, which should give me the low phase noise of the 10811A, with a decent holdover time from the PRS10 if there is no GPS signal. _______________________________________________ time-nuts mailing list [email protected] https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
