Yep, That is the same type used by HP and Keithley as input connectors on some of their volt meters.
-Chuck Mike Feher wrote:
Dave - Like I said, I knew it was "triaxial", but I just have never seen this configuration. I am sure there are a lot of other things I have yet to see. Regardless, like I said, this looks like it is going to be a project of changing out all of the connectors. Attached are a couple of quickly taken photos, reduced in resolution for quick access. One shows part of the rear of the distribution amp whit the female sockets and the other the male end of a terminating connector that came with the set. Seems everything I get on ebay turns into a project. I have seen isolated BNCs before, like on Tektronix scopes, but these are new to me. But who knows, if I look hard enough in the basement I just may find a bunch of mating sockets. Thanks for the help. Regards - Mike
_______________________________________________ time-nuts mailing list [email protected] https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
