In message <[EMAIL PROTECTED]>, Brian Kirby writes: >You may have a "bias" error. Try connecting 1 PPS to the start input >and stop input via equal length of bnc barrels or two very short >pieces of matched length cable. Run your measurements again - you mave >have to subtract the "bias" from your measurements to get a true reading.
If this is a 5370B there is an easier way: Use TI+/- mode, and measure first from start to stop, then from stop to start and take the average. -- Poul-Henning Kamp | UNIX since Zilog Zeus 3.20 [EMAIL PROTECTED] | TCP/IP since RFC 956 FreeBSD committer | BSD since 4.3-tahoe Never attribute to malice what can adequately be explained by incompetence. _______________________________________________ time-nuts mailing list [email protected] https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
