George,
Its a good chance that the GPS receiver used is a Trimble
Acutime/Acutime 2000 or Acutime II, since they are used with most
Bancomm bus level timeing cards. (bc627AT, bc637PCI 12043/PMC/CPCI)
They usually are connected with a HD DSUB15 (like the VGA connector),
but it seems the PMC card uses a DSUB9. Check table 7-4 in
http://www.symmttm.com/pdf/Bus/um_8500_0096.pdf
Does your DSUB9 have 12VDC(with +100mA sourcing) at pin 9? Ground at pin 3?
Maybe you can
trace some pins and see if they end up going to a 422 receiver/sender?
(Do not blame me, if you break anything...)
The present Acutime2000 has a 12pin interface, older versions had a
7pin.
good luck!
--
Björn
<[EMAIL PROTECTED]> writes:
> Folks
>
> I may have given the wrong impression.
>
> I have a DATUM BANCOMM MODEL TS 2000.. The antenna cvonnector is a DB9! I
> think this antenna may have contained the entire RF assembly.
>
> Thanks
> George
> _______________________________________________
> time-nuts mailing list
> [email protected]
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
_______________________________________________
time-nuts mailing list
[email protected]
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
