Jason Rabel wrote: > A good initial buffer chip for all the TTL signals would be an IDT QS3384 > with 10 inputs/outputs. > Jason,
The only problem with that part is that it's not a buffer! It's a switch. It has no drive capability at all. There are useful buffer chips for this task, but their names escape me just now. Perhaps the 74FCT245 or equivalent would work. Driving a full 5V TTL signal into a 50 ohm load is another matter - you need a lot of DC power (1/2 watt) to do that. I was just using a Liner Tech LT1010 for a similar job - it would get the job done, but folks here might complain about the phase noise. _______________________________________________ time-nuts mailing list [email protected] https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
