Hi Gerald, I don't think you can find much simpler than James Miller's project: http://www.jrmiller.demon.co.uk/projects/ministd/frqstd.htm
Lots and lots of people have built it. If you do not use a Jupiter receiver, you will need more dividers (the Jupiter outputs 10 kHz in addition to the 1 PPS, which James uses in his project) but for experimentation, you could build this bread-board style. Didier KO4BB [EMAIL PROTECTED] wrote: > Hi nuts, > > Since signing up to Time-nuts some time ago, there has been a lot of > discussion > relating to GPS disciplined frequency standards. Infact, the information > is overwhelming but wonderful reading, but I must admit to some extent > fragmented, > but for a reason, mostly replies. > > For the past 20 years I have played with TXCO's and more recently Rubidium > frequency standards to provide my workshop and test gear with an accurate > 10MHz clock with minimal phase noise and Freq drift. > > In reading the many wonderful comments, suggestions and feedback and so on, > I was wondering if I could ask you all for some advice on the best way to > proceed with building a 1pps PLL so that I can lock my Rubidium FRS/LPRO/TXCO > to my Oncore M12+ or VP that is just sitting there doing nothing at the > moment. > > I am keen to build something myself from scratch, however some of you may > say the best way forward is to look at Brooks Shera's article and go the > whole hog. I think Brooks GPS based frequency standard is fantastic and I > am sure worth every Dollar well spent, however I am looking for something > very simple to experiment with firstly, e.g. 4046 PLL, understand 1pps and > then move up. > > Don't all speak at once, no just kidding. I am looking forward to your > replies. > > Cheers > > Gerald > > > > > > _______________________________________________ > time-nuts mailing list > [email protected] > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > > _______________________________________________ time-nuts mailing list [email protected] https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
