Jason Rabel wrote: > I'm not sure what happened, if there was a short before or I just missed it > because the signal was so low, but now I'm getting a signal! > > It is extremely weak, only about 30mV p-p w/50 Ohm termination. Any thoughts > (besides the AGC circuit)? > > I tried to adjust R6, but it was already near maxed out. The manual says: > > If the R6 adjustment isn't effective, you should suspect the AGC circuitry > (Q3, CR4, CR5, C5, C6, R5, R6, R7, or Q1). > > This kind of sucks because working on that middle board is not fun. I guess > I'll have to disconnect the thermistor & crystal so I can pull it out from > the metal shell. > > I *thought* I saw a parts list somewhere, but I'm looking through the manual > again and don't see it. The schematic on page 64 (Adobe pg 72) doesn't give > info except on capacitors. > > At least I know it isn't dead, so that's a positive. :) > > > Jason > > > _______________________________________________ > time-nuts mailing list > [email protected] > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > > Jason
The 10811 service manual contains a complete parts list on pages 32-34. Bruce _______________________________________________ time-nuts mailing list [email protected] https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
