Lester I have no idea you'll need to contact Acam direct. http://www.acam.de
Bruce Lester Veenstra M0YCM K1YCM wrote: > What is the cost of the two channel pci system, if you happen to have the > price in hand. If not, I will ask direct. > > Full Name: Lester B Veenstra > Job Title: Communication Sys Des Engr Sr Stf > Department: 6L01 Site Operations Collaboration and Reach-Back (SOCAR) > Company: Integrated Systems & Solutions > > Business Address: > > Lockheed Martin IS&S > PSC 45 Box 781 > APO AE 09468 > > Home Address Address: > > Dawn Cottage > Norwood, Harrogate > HG3, 1SD UK > > Telephones: > > Office 940-6456 > > Office +44-(0)1423-846-385 > > Home: +44-(0)1943-880-963 > > UK Cell +44-(0)7716-298-224 > > US Cell +1-240-425-7335 > > Jamaica +1-876-352-7504 > > > -----Original Message----- > From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On > Behalf Of Dr Bruce Griffiths > Sent: Saturday, May 12, 2007 7:00 AM > To: Tom Van Baak; Discussion of precise time and frequency measurement > Subject: Re: [time-nuts] Software Sawtooth correction prerequisites? > > Tom Van Baak wrote: > >>> Define cheap. >>> You can already get essentially single chip TICs with a resolution (and >>> accuracy) better than 100ps for around 100 Euros or so. >>> >>> >> Has anyone in the group tried one of these? I would very >> much like to see the results. >> >> > > All except Xavier seem to have shied away from obtaining these on cost > grounds and the need to layout a 4 layer PCB. > Although the vendor does offer an evaluation system (External box plus > card plugs into PC with fat multiconductor SCSI type (but not SCSI > signalling)cable connecting the two), too expensive for general use but > perhaps useful for performance evaluation. > The above price was for an earlier version the later reduced cost higher > resolution version (range 5 nanosec - 4millisec) should be cheaper. > The range can easily be extended to years if required (using CPLD > counters (or even a PIC with built in counters - eg PIC18F4550) + > software+ 74AC164). > > Bruce > _______________________________________________ time-nuts mailing list [email protected] https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
